KA-GC9A (جديد)

9-Axis Electronic Compass Heading Sensor with built-in High-accuracy GPS Module

KEY FEATURES

  • Low power consumption, 450mW
  • Power supply : 5V-32V, reverse polarity protected
  • Embedded firmware upgrade through proprietary NMEA messages
  • Runtime user calibration
  • 9 axis inertial measurement unit (IMU) magnetometers, accelerometers & gyroscopes datafusing with proprietary algorithm
  • Windows graphical user interface (9 axis E-Compass Manager) for easy setup, monitoring and upgrades

When you turn over the KA-GC9A you can see an arrow sign on the antennabase. Please  make sure this arrow should point exactly to the BOW direction.

CG 9A

Example: Connect KA-GC9A to ONWA KP-27X

Snipaste 2024 07 17 14 26 05

Snipaste 2024 07 17 14 34 24

 INTERFACE (NMEA0183 VER 2.0)

 

Baudrate

4800/9600/19200/38400 Selectable

Output Sentences

GPRMC, GPGSA, GPGLL, GPZDA, GPVTG, GPHDT(5Hz)
NOTE: all output sentences are in intervals of 1 Hz unless specified

Electrical

RS422, 18KV ESD

Power Supply

5V-32V, Over-voltage and reverse polarity protected
Power consumption: 450mW

User-Interface 

Uses 9-Axis E-compass Manager

IMU(Inertial Measurement Unit)

9-Axis(Features a GPS/Glonass receiver coupled with a 9-axis AHRS unit providing 3D orientation by integrating gyroscopes and data fusing with accelerometers and magnetometers)

Equipment List

KA-GC9A with 10m cable 1set

Main unit

IN 1 1

one flat base

IN 2 1

Four long screws  (TA5-20)

     IN 3

two short screws  (ST4-6)

IN 3 1

two screw buckles

IN 5

one wire thread buckle

IN 6

one Sealing plug

IN 7

a wrench

IN 8
Contact